How To Remove Wall Mounted Soap Dispenser

The water dissolves congealed soap.

How to remove wall mounted soap dispenser.

Once the dispenser is down you may need a little lighter fluid to help remove the rest of the residual gunk. How to install a shower soap sol shampoo dispenser. Wipe off the dispenser tube with a paper towel then immerse the entire assembly including the pump and the tubes in warm water. Look inside the dispenser.

Scott the kemsol guy shows you how to change an empty soap refill in the touch free gojo hand soap dispenser. The mounting surface must be clean and dry in order for the tape to stick and the silicone to. Choose the mounting location carefully making sure that there will be enough room above the unit to remove and refill the soap sol. The top should swing away from the wall and hang down.

Just use a cotton cloth to apply the fluid and rug vigorously. You will see a small lever or bar near the wall on the bottom of the dispenser. If you are replacing a previously mounted soap dispenser remove the screws and nails with a screwdriver. 2 drill holes into the marked points using rawl plugs to keep the screws in place if you choose not to use holes left behind from a previous wall mounted soap dispenser.

Leave it for 5 minutes. Wash the cloth immediately in the sink when you are done. Set the soap dispenser aside. Look underneath the soap dispenser behind the push bar and soap nozzle.

Push this lever while gently pulling the top of the dispenser toward you. Unscrew the cap from the soap container and remove the dispenser pump assembly.