How To Repair Garage Door Panel

There are several ways you can fix the bend in the garage door panel.

How to repair garage door panel.

If so it may be possible to repair your garage door panel with wood filler paint and or a strut. Removing the old panels. Attach the new panel to the one below it using either screws or a bolt depending on the existing fastening on the door. How to fix a bent garage door panel.

Once this is done open up your garage door and remove the springs. There s a lot of tension in the springs so be. Hammer out the bend. If it s connected to an electric opener unplug the opener.

Raise the garage door and disconnect the power to the automatic garage door opener if applicable. How to fix a garage door panel step 1. Instead of having entire sections of a garage door replaced this video will show how to repair of warped panels to restore the appearance of an older garage. Caulk around the exterior side of the panel for added protection.

This will make sure that the door does not spring open when you are working on it. On the other hand if the door was struck by a car someone tried to use the automatic opener when the door was locked or your garage was hit by a hurricane or earthquake the damage may affect much more than the individual panel and could threaten the safety of anyone using your garage. Here are some of the best fixes available to you. Check that all the fastenings are tight.

If it s a simple dent then this shouldn t be too hard to do. Stand on a ladder and unhook the. Undo the tension springs from the turnbuckles holding them in place. Unbolt the track rollers from either side of the panel with a socket wrench.

Reattach the other panels in the order you removed them until the whole garage door is back in place. Your garage panels are attached to each other and the track rollers. Once this is done close the garage door holding it all the way down. Carefully lower the door.

This panel will still be in place on the garage door. Fit the new piece of panel into the hole and use caulk and finish nails to attach the quarter round back around the interior of the panel to secure it in place. Use a scrap 2 by 4. One of the most simple fixes you can do is hammering out the bend in the door.