How To Reprogram Genie Garage Door Opener Remote

Step 2 press and hold the learn button on the side of the power head for approximately 10 seconds or until the indicator light turns off.

How to reprogram genie garage door opener remote.

The light on the opener should blink and the garage door should open. Just make sure you remember the button you pressed as this will be the button that opens and closes your garage door. If your device was made between 1995 and 1997 then the remote button format will look a little different. This will lock in a new code and you will be able to use your remote controls normally.

If not try the process again. The power head is attached to the ceiling of your garage. Press and release the learn code button on the receiver while the red led is blinking press your transmitter button 3 times. Press the button on the remote to test the opener.

Programming your genie garage door remote is super easy. Repeat this process for each additional remote control you have. In this how to video i show you the fastest and easiest way to do this. Place the ladder under the garage door power head and climb so you are within reach of the control buttons.