Fill holes and repair imperfections with sandable filler or spackle.
How to sand a 6 panel door.
Lightly sand the primer with 220 grit inspecting as you go.
Paint the edges and wipe off the slop.
Let the primer dry overnight before sanding.
Dust and sand with 280 grit paper then put on the final coat.
The main goal is to give your door a little tooth for the new paint or primer to adhere to.
For more and better information take a look.
Back off the sandpaper and use a synthetic steel wool 3m multi flex is what i use for the raised panel and detail parts of the door.
Dust the door and wipe it down with a tack cloth.
Before painting clean the door with a degreasing cleaner.
This free video diy guide provides some much need help.
Happily refinishing a door is easier than you might think.
Remove the hinges deadbolt door knob and any other hardware.
Spread the wood filler and allow it to dry.
When that s dry reattach the door hardware.
Take the door off the hinges and place it horizontally on sawhorses.
No need to bust out the power sander you can use a sanding block or sheet of sand paper.
Brush or roll paint onto all four edges.
Hand sand small spots or leave them and sand it while sanding your door.
Lightly sand the entire door.
Brush all of the sanding dust off of the door with an old soft bristle paintbrush or use a shop vac to suction it off.
Brush on the second coat following the same order and let it dry overnight.
Put down drop cloths.
A couple of quick passes is all it takes.
Place a 220 grit sanding disc on the orbital sander and sand all of the flat areas again.
Use 120 grit sandpaper to gently sand the door for a smoother surface that will absorb primer or paint more easily.
Turn the door over and repeat all of the previous steps.
Use a section of 220 grit hand sandpaper to sand the area around the raised panels.
The longer it dries the better it will sand.
Use a hand figuring out how to go about refinishing a pine door.
For cracks in the door scrape or sand off any rough or raised edges.
It s so easy in fact that this clip can present a complete overview of the process in just over two and a half minutes time.
Sand the door again with 150 grit followed by 220 grit sandpaper.
A good sand job on a heavily detailed cabinet door shouldn t take more than 15 minutes 7 8min per side.
Sand the door down to bare wood with 100 grit sandpaper.