The door handle will now slide off.
How to take apart door handle without screws.
Push the tip of a narrow screwdriver into the hole.
Many door knobs have trim plates that cover the screws so removing them can be a bit tricky if you ve never done it before.
Take your flat philips screwdriver and place it in the gap.
Depending on the door handle design the faceplate may be able to slide completely off.
With some pressure you can move the clip inside.
If the plate is difficult to remove by hand insert a flat head screwdriver under the edge of the plate plate where it meets the door surface prying outward using gentle pressure.
Look for the tiny gap on the side of the door knob.
Keep one hand on the outside section of the door knob to keep it from falling on the floor.
Pull the screws from the.
If any screws are exposed during this process remove them to release the lock and remove it from the door.
There should be a small latch near the base of the knob or handle probably on the exterior side of the door.
After applying some pressure you can pull the door knob towards you.
To remove a door handle without any visible screws start by prying off the cover plate by inserting a flathead screwdriver in the notch on the side of the plate.
If not rotate the faceplate until the underlying screws are accessible and use a phillips head screwdriver to remove them.
Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.
Straighten a paper clip and insert it into the hole.
If you don t see a notch and the cover plate is round try turning the plate counterclockwise to remove it.
Turn each screw holding the knob body to the door with a phillips screwdriver.
But you ll have to take the knob off first.
Remove door knob without screws.
Push this latch in and pull the handle off the door.
How to remove a door knob without screws or a latch locate the hole underneath the doorknob shaft.
Our quick video shows you how si.
You should see a tiny slot or hole.
Simply unscrew these screws unscrew the latch from the door edge and remove all the pieces.
Slide the cosmetic faceplate away from the door.
Next find a small slot on the edge of the trim piece.
