How To Take Door Panel Off 2008 Chevy Silverado

Using a suitable flat bladed tool gently pry the manual lock lever from the door trim panel.

How to take door panel off 2008 chevy silverado.

Move to the bottom edge of the door panel carefully insert a flathead screwdriver or an automotive trim panel removal tool and gently pop out the friction fasteners. Don t worry about removing the cable you only have to do this if you need to remove the whole door panel. Continue pulling on the bottom and sides of the panel to disengage all of the white plastic friction fasteners. Remove the door trim panel upper extension.

Remove the 10mm bolt inside the door handle. Remove the two 10mm bolts inside the door pull. Pry off the trim piece inside the door handle with a flat blade screwdriver. Removing the door panel 0 35 pry off the trim piece inside the door pull with a flat blade screwdriver.

Several different reasons exist for removing a door panel on a chevy silverado. Once you remove the screws just use a screw driver or pry bar to pop the bottom of the door panel off so you can see up inside. Gently lift panel up. You just need to be able to get the bottom of the door panel to swing out about a foot or so.

Use your pick to get behind the shark fin and pull it away from the door so you can get your finger behind it and it will pop off. It has three clips two that snap into the door frame and one that snaps into the door panel. Then you will be able to reach the connector for the mirror and disconnect it. You may need an additional screwdriver to help you pop it off the door panel to prevent damage.