How To Tighten Up Loose Sliding Closet Door Frame

First check that the hinge screws are tight.

How to tighten up loose sliding closet door frame.

If your doors hang from a top rail and do not have a track on the floor then you need to either replace or tighten down the floor guides. 1 reason that doors fail to shut tightly is that the hinges loosen over time causing the door to sag. If a malfunctioning sliding door is a chronic problem see if the track is dirty. If your door rubs near the top or drags on the floor use a screwdriver not a drill to tighten the screws.

The standard height is 80 inches the same as for an entry door. Screws magically work themselves loose over the years. Tightening the door hinges may solve the problem by pulling the door back toward the jamb the hinged part of the frame so it no longer catches on the frame when you try to close it. Sliding closet doors are loose and swing in and out the first thing to check is what type of rail system your sliding closet door uses in order for it to slide.

Open the door grasp it. Tighten the hinge screws. Tighten the screws on the hinges as much as possible and then try closing the door to see if the problem is fixed. Lucky for you it is easy to tighten loose hinges and make your doors work like new.

Most hinge problems can be solved with nothing more than a screwdriver. To reassemble snap the rose back on the chassis depress the release button and slide the knob back on until the button pops through the hole. To clean and lubricate the hardware of a sliding closet door use a stiff brush a toothbrush or a hand vacuum to clean dust from the tracks. If you have an older home with 9 or 10 foot high ceilings this can leave you with unusable space above the doors.

Fix it the right way not the wrong way. When this happens you ll likely see that the bottom of the door is lower along the lock side than the hinge side. Because sliding doors don t fold out the way bifold doors do they allow access to only half the width of the opening at a time. Loose hinges can cause a door to stick bind or scrape the floor.

The wrong way is a temporary fix not cool. Use an aerosol lubricant to lubricate all the door rollers. Built up dirt or loose debris can cause a door to stop sliding and ride off the track. With a drill you re more likely to over tighten the screw and strip the screw holes or chew up the screwheads.

Tighten the door hardware by opening the door squeezing both sides of the assembly together and tightening the two screws on the chassis. Either build shelves with small doors above the closet or custom make bypass doors that are tall enough to suit your situation. Finish up with a rag an turpentine if necessary. Make sure all the screws are tight.