How To Use A Roof Harness

Throw rope with at.

How to use a roof harness.

1 pull the entire throwing line over the roof until the rope is reached. Adjust the harness buckles for a snug fit. Tie rope to a structural part of house or a tree. Never reuse a harness or lanyard that has been.

Don t work more than 4 ft. Here are a few of the key points. This is a complex system high line rope operation that we set up for a large 2 story tile roof. Anything can happen and the littlest mistake can send you falling off the roof.

To access a roof you ll need an extension ladder. Fall arrest and f. Discussing roof safety and fall protection. With a hammer nail a row of roof brackets about 3 feet apart and 16 inches up.

How to put on a fall arrest harness slip the harness over your shoulders like a vest. Stay well away from power lines and don t put ladder across. Make sure the d ring is in the middle of your back directly between your shoulder blades. So by following these few easy steps you can properly use a roof safety harness.

Learn how to properly don a peakworks safety harness. Locate the roof anchor directly above where you ll be working on the roof. Step 1 nailing on the roof brackets. Inspect the harness and lanyard for loose stitching and worn webbing.

When dealing with roof safety always wear a roof safety harness. Unroll the throwing line and toss the throwing bag over the sloping roof. Attach the remaining end of the throwing line to the rope. Inspect the roofing harness for any damage put on the harness and adjust the shoulder straps make sure the d ring is upper middle part of the shoulder adjust the leg straps adjust the chest straps final adjustment for a fit snug but still allow for a full range of movement.