How To Set Up Garage Door Springs

When the door is closed the spring is wound.

How to set up garage door springs.

Retest the door balance as you did in step 1. Look for a reddish cone on the torsion spring. Through the use of pulleys they perform the same function as the torsion springs. They come under tension when the garage door is closed to make lifting the.

They do this so that it won t fall down on them. When your garage door is open the springs are relaxed. The cone is on the torsion spring on the left side away from the. Use a tape measure to carefully record the length and width.

Once the spring is free of tension remove from its track hanger. To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller. Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension. When you close it they twist or extend to hold your door shut.

This tension makes it easier to lift the garage door from its closed position. If it was opening too quickly move it to the next lower hole. Side mounted springs are long heavy springs mounted on each side of the upper garage door track. As part of maintaining your garage roller door it is important that the roller door is tensioned properly.

If the door was closing too quickly move the spring to the next higher hole on the bracket. Many diyers close their garage door before working on it. At a home improvement store purchase some rubber weather stripping. How to adjust a torsion spring garage door step 1.

The springs extend along the shaft and work by twisting as the garage door closes by means of cables attached to each side of the lowest garage door panel. Adjust the springs on both sides of the door the same way. Lay weather stripping over the bottom door panel. This helps maintain the life of your garage door o.

The torsion springs on steel rolling doors work the same way as other torsion springs in the garage door industry. However most of them do not understand how garage door springs work. The spring is secured to a spring anchor bracket on one end and to the shaft on the other. When the steel rolling door opens the spring in the barrel supports most of the door weight.

Measure the garage door opening before purchasing panels.